[1]马姝雅,李洋洋,郝梦亚,等.基于RSM模型的微波耦合Fe0/H2O2破解污泥分析[J].中国给水排水,2021,37(21):100-106.
　MA Shu-ya,LI Yang-yang,HAO Meng-ya,et al.Analysis of Microwave Coupled with Fe0/H2O2 for Sludge Disintegration Based on Response Surface Methodology[J].China Water & Wastewater,2021,37(21):100-106.
点击复制

基于RSM模型的微波耦合Fe0/H2O2破解污泥分析

中国给水排水[ISSN:1000-4062/CN:12-1073/TU] 卷: 第37卷 期数: 2021年第21期 页码: 100-106 栏目: 出版日期: 2021-11-01
Title:
Analysis of Microwave Coupled with Fe0/H2O2 for Sludge Disintegration Based on Response Surface Methodology
作者:
马姝雅，李洋洋，郝梦亚，朱薇，岳秀萍,端允
(太原理工大学环境科学与工程学院，山西太原030024)
Author(s):
MA Shu-ya,LI Yang-yang,HAO Meng-ya,ZHU Wei,YUE Xiu-ping,DUAN Yun
(School of Environmental Science and Engineering, Taiyuan University of Technology, Taiyuan 030024, China)
关键词:
污泥破解率; MLVSS/MLSS; 响应曲面法; 微波; 类芬顿反应
Keywords:
sludge disintegration degree; MLVSS/MLSS ratio; response surface methodology (RSM); microwave; Fenton-like reaction
摘要:
采用微波耦合Fe0/H2O2(MW—Fe0/H2O2)工艺调理剩余污泥，探究其对污泥破解性能的影响。运用以响应曲面法(RSM)为依据的Box-Behnken设计，以pH值、微波能量（W）、H2O2/Fe0值为影响因素，建立污泥破解率(DD)和MLVSS/MLSS值的预测模型，以实现对工艺参数的优化。结果表明，当初始pH值为2、W为450 kJ/L、H2O2/Fe0值为3时，污泥氧化破解程度达到最佳，此时DD的响应值为(32.42±0.30)%，MLVSS/MLSS的响应值为(23.12±0.47)%，与模型预测结果吻合较好。结合污泥粒径测定结果和扫描电镜观察结果可知，该工艺可使污泥颗粒显著减小，污泥絮体结构破坏完全，从而提高污泥破解程度。
Abstract:
The microwave coupled with Fe0/H2O2 (MW-Fe0/H2O2) process was applied to condition the excess sludge, and its effect on the disintegration performance of the sludge was investigated. The Box-Behnken design based on response surface methodology (RSM) was applied to establish the prediction models of sludge disintegration degree (DD) and MLVSS/MLSS ratio with pH, microwave energy (W) and H2O2/Fe0 ratio as the influencing factors, so as to realize the optimization of the process parameters. When the initial pH was 2, microwave energy was 450 kJ/L and H2O2/Fe0 ratio was 3, the disintegration degree of the sludge was the best. Under these conditions, the response value of DD and MLVSS/MLSS were (32.42±0.30)% and (23.12 ± 0.47)% respectively, which were in good agreement with the predicted values of the model. According to the measurement results of sludge particle size and the observation results of scanning electron microscope, the process could significantly reduce the sludge particle size and completely destroy the structure of the sludge flocs, so as to improve the sludge disintegration degree.
更新日期/Last Update: 2021-11-01