[1]顾瑞环,刘旭阳,毕学军,等.曝气量分配和填料填充率对MBBR氧转移效率的影响[J].中国给水排水,2023,39(1):1-8.
　GURui-huan,LIUXu-yang,BIXue-jun,et al.Effect of Aeration Distribution and Carrier Filling Rate on Oxygen Transfer Efficiency of MBBR[J].China Water & Wastewater,2023,39(1):1-8.
点击复制

曝气量分配和填料填充率对MBBR氧转移效率的影响

中国给水排水[ISSN:1000-4062/CN:12-1073/TU] 卷: 第39卷 期数: 2023年第1期 页码: 1-8 栏目: 出版日期: 2023-01-01
Title:
Effect of Aeration Distribution and Carrier Filling Rate on Oxygen Transfer Efficiency of MBBR
作者:
顾瑞环1， 刘旭阳2， 毕学军2， 孙贤鹏3
（1.青岛水务集团，山东 青岛 266071；2.青岛理工大学环境与市政工程学院 城镇污水处理与资源化国家地方联合工程中心，山东 青岛 266033；3.青岛市排水运营服务中心，山东 青岛 266000）
Author(s):
GU　Rui-huan1， LIU　Xu-yang2， BI　Xue-jun2， SUN　Xian-peng3
（1. Qingdao Water Group， Qingdao 266071， China； 2. State and Local Joint Engineering Research Centre of Urban Wastewater Treatment and Reclamation， School of Environmental and Municipal Engineering， Qingdao University of Technology， Qingdao 266033， China； 3. Qingdao Drainage Operation Service Centre， Qingdao 266000， China）
关键词:
移动床生物膜反应器（MBBR）;  填料填充率;  氧转移效率;  曝气强度;  管道阀门开启度
Keywords:
moving bed biofilm reactor (MBBR);  carrier filling rate;  oxygen transfer efficiency;  aeration intensity;  valve opening of pipe
摘要:
针对曝气量分配方式及填料填充率对移动床生物膜反应器（MBBR）氧转移能力的影响问题，以青岛市某污水处理厂的MBBR单元为研究对象，以标准氧转移效率（αSOTE）为评价指标，通过正交试验确定了最优曝气量分配方式；在特定曝气系统阀门开启度工况下，采用尾气法对不同填料填充率（28%、33%、38%、43%）条件下好氧池沿程各测点处的αSOTE进行了连续72 h测试，最后通过整池平均αSOTE指标评价填料填充率对MBBR氧转移能力的影响。结果表明，在高长宽比（2.6∶1）MBBR反应器和高水流行进流速（36 m/h）条件下，当MBBR进水端、中部区域、出水端的曝气量分别采用中气量、低气量、高气量时，可在反应器内形成反向推流流态，避免填料堵塞；同时，在低填料填充率条件下可关闭穿孔曝气，降低曝气强度，节省能耗。随着填料填充率由43%逐渐降低至28%，MBBR整池平均αSOTE可由19.3%提高至30.2%。
Abstract:
To investigate the effect of aeration distribution and carrier filling rate on oxygen transfer capacity of moving bed biofilm reactor (MBBR), the standard oxygen transfer efficiency (αSOTE) was selected as the evaluation index, and the optimal aeration distribution mode of a MBBR unit in a wastewater treatment plant in Qingdao was determined by orthogonal experiment. Under the condition of specific valve opening of the aeration system, the αSOTE at each test point along the aerobic tank with different filling rates (28%, 33%, 38% and 43%) was tested by off-gas method for 72 hours. Finally, the effect of carrier filling rate on the oxygen transfer capacity of MBBR was evaluated by the average αSOTE of the whole tank. Under the condition of large aspect ratio (2.6∶1) of MBBR and high flow velocity (36 m/h), the reverse push flow state was formed in the reactor to avoid carrier blockage when the medium aeration rate, low aeration rate and high aeration rate was adopted respectively in the inlet, middle area and outlet of MBBR. In addition, the coarse?bubble aeration could be closed when the carrier filling rate was low, so as to reduce the aeration intensity and saving energy consumption. With the carrier filling rate gradually decreasing from 43% to 28%, the average αSOTE of the whole MBBR was increased from 19.3% to 30.2%.

相似文献/References:

[1]梁一帆,潘增锐,喻盛华,等.MBBR污水生化处理系统中泥膜的生物群落分析[J].中国给水排水,2023,39(23):15.
　LIANGYi-fan,PANZeng-rui,YUSheng-hua,et al.Microbial Community of Sludge and Biofilm in a Moving Bed Biofilm Reactor[J].China Water & Wastewater,2023,39(1):15.

更新日期/Last Update: 2023-01-01